What are the methods to distinguish the new and old enamel reactor

Enamel reactor manufacturers in the purchase of reactor, usually have to carry out a series of inspection, in order to ensure that the equipment is new, general inspection methods are diverse, here, we briefly introduce to us the common enamel reactor manufacturers purchase equipment when the choice of viewing method.

Can first look at the weld, the new enamel reactor is flat, no repair marks, and used enamel reactor of the outer weld, after the general renovation of the weld will have repair marks, can be observed. Another thing is to observe if there are any marks around the discharge port under the reactor body. If the new equipment is forged and welded, the spray paint surface will be very smooth, leaving only a little trace of the forging process. However, the condition of the renovation will be different, although some will deal with the relatively smooth but the place on the flange must have rust, even if the removal of rust, but also leave traces.

The new reactor at the place where the reactor body is intercalated into the steam usually has a steam separation device to avoid the situation of the shock of the steam being too large and causing the porcelain to fall off, and if the reactor is old, then the gas separation device probably does not exist, again with us to suggest a way, really uncertain situation can find the determination of the unit with a detector to measure the wall thickness.

When we use enamel reactor equipment, we should learn to look at the old and new methods, if it is a shortage of experience in this area, then try to choose large enamel reactor manufacturers to buy equipment, this will reduce the chance of getting refurbished equipment.